Go to the red triangle in the graph and select Local Data Filter.I hope this gets you to where you want to be You can now select the different X columns and the graph will change, but the Y axis remains the same The code below works(it shows bar graphs of the column 3 to n) but there is one thing i'd want to do. Because you do not want the Y axis to change when selecting the different X's, uncheck the Include check box, and since the graph is now to a completed state, you can click on the Done button Hi, im new to the jmp scripting language.Select the Label column and click on the "+" Also, once the Lines of Fit are displayed, go to the Line of Fit control area and unselect Confidence Fit Now, to add a line of fit, right click on the center of the graph and select Add=Line of Fit.In the Local Data Filter, select Label and click on the "+" Go to the red triangle of the chart, and select Local Data Filter.Drag the Label column to the Overlay drop area.Click on the center of the graph and select Smoother=>Remove.In the Graph Builder display, drag the Y column to the Y drop area and the Data column to the X drop area.Go to the pull down menus at the top of the stacked data table and select Graph=>Graph Builder.A new data table is displayed with all of the x columns stacked.Select the 5 X columns as move them to the Stack Columns selection box and then click OK.The X columns need to be stacked to work properly with the Filter that is going to be used, so go to the pull down menus at the top of the data table and select Tables=Stack.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |